Description
This base coat has a modernized composition and has been successfully tested for allergy sufferers. Therefore, the use of HEMA FREE Base is the maximum comfort and safety for clients with any nail plate, and especially for people with hypersensitive nails. Due to the consistency of medium viscosity, the material is well distributed on the surface with minimal effort of the master. As a result, you get a high-strength coating of medium hardness. Rubber HEMA FREE Base is a guarantee of safety for both the master and the client.
BENEFITS:
modernized composition;
the absence of HEMA monomer in the composition;
tested on allergy sufferers;
super adhesion;
flexibility and moderate stiffness;
hypoallergenic formula 12 FREE;
exothermic reaction is less pronounced during polymerization;
does not heat up on nails to high temperatures, does not cause unpleasant sensations during polymerization;
suitable for thin, damaged and sensitive nail plate;
perfect consistency for nail alignment;
wide range of possibilities: strengthening, restoration, extension of free edge/corners up to 2 mm in length;
durable coating, without chips and peeling up to 28 days.
THIN COATING. MODE OF APPLICATION:
Prepare the nail plate with PNB buff, remove the gloss.
Apply auxiliary fluids: Nail Dehydrator and Bond Control to the entire plate.
Apply a very thin layer of HEMA FREE Base PNB, seal the free edge, dry for 60 seconds.
Apply a thin layer. Cure in a lamp for 60 seconds. If necessary, remove the stickiness with Gel Cleanser PNB.
Perform coating/design, apply PNB top.
LEVELING TECHNIQUE. MODE OF APPLICATION:
Prepare the nail plate with PNB buff, remove the gloss.
Apply auxiliary fluids: Nail Dehydrator and Bond Control to the entire plate.
Apply a very thin layer of HEMA FREE Base PNB, seal the free edge, dry for 60 seconds.
Apply a second very thin layer of HEMA FREE Base PNB, place a drop of base on the highest point of the nail and stretch it evenly to the free edge.
Cure in a lamp for at least 1.5 minutes.
If it necessary, remove the sticky layer with Gel Cleanser PNB.
Perform coating/design, apply PNB top.
RECOMMENDATION:
for the absence of sensations, the thickness of the coating should not exceed 1 mm;
when aligning the nail plate, the thickness of the coating should not exceed 1.5 mm for complete polymerization of the product. It is recommended to work in a conveyor way, polymerizing each nail for a few seconds, and finally ー complete drying for 1-2 minutes, depending on the type of lamp and power;
the exothermic reaction is more pronounced in summer at temperatures above 25 degrees. To avoid this, it is desirable to have air conditioning in the workplace;
you can also use Low Heat Mode.
